Precision Automated
Systems
Precision VST X1
Our standard VST X1 System is our flagship motor assembly that impressively powers 75% of the door systems we automate.
The VST X1 is the perfect solution for in-line or equal bi-part systems.
​
The VST X1 motor is controlled by our
​
​
Material
​
-
One-piece milled aerospace-grade aluminum black anodized head bracket.
-
One-piece milled aerospace-grade aluminum black anodized drive pulley.
-
Dual bore stainless steel drive pulley set screws.
-
Sealed stainless steel head bracket bearing.
Mounting
​
-
Milled countersunk perimeter holes for ultimate installation stability.
-
Two countersunk installation support templates.
-
3-sided motor board installation bores.
-
Designed for both in-line or perpendicular vertical installation.
-
Front or side drive belt feed for ultimate installation flexibility.
Motor Dimensions
Back
Side
Front
Precision VST X1 Inverted Kit
When there is limited room to mount the motor traditionally, the X1 Inverted Kit is the solution.
​
The motor mounts above the door header, with a 12-inch stainless steel shaft dropping the drive pulley into the head track.
​
No space, No problem, we'll invert it!
Inverted Kit Includes:
​
-
One-piece milled aerospace-grade aluminum black anodized head bracket.
-
One-piece milled aerospace-grade aluminum black anodized drive pulley.
-
Single bore stainless steel drive pulley set screw.
-
12-inch stainless steel shaft (shaft cut-to-length).
-
Precision shaft coupling.
-
Two bearing stabilizing brackets.
-
Sealed stainless steel ball bearings.
Precision VST X1 Inverted Right-Angle Kit
No space above the door either; no worries, we got you covered there too. Our Inverted Right Angle Kit will install in headers with less than 8-inches.
​
Like the inverted kit, the right-angel kit motor mounts above the door header, with a 12-inch stainless steel shaft dropping the drive pulley into the head track.
Right-Angle Inverted Kit Includes:
​
-
Right-angle gearbox
-
One-piece milled aerospace-grade aluminum black anodized head bracket.
-
One-piece milled aerospace-grade aluminum black anodized drive pulley.
-
Single bore stainless steel drive pulley set screw.
-
12-inch stainless steel shaft (shaft cut-to-length).
-
Two Precision shaft coupling.
-
Two bearing stabilizing brackets.
-
Sealed stainless steel ball bearings.